Filter Result By

Browse

Manufacturers

Hughes Mobile Shower with Eye/Facewash

Hughes Mobile Shower with Eye/Facewash

Manufacturer: Hughes

Product Code: STD-MH-P-2000

 

Hughes Mobile Shower with Eye/Facewash

 

Heated & Self-Contained Mobile Shower & Eye/Facewash with Submersible Water Pump


The Mobile Self-Contained Emergency Safety Shower has a capacity of approximately 2000 litres and gives a constant flow of water for over 15 minutes. The 2000 litre green polyethylene tank incorporates an electric submersible pump which requires either a mains or generator-fed electricity supply. An integral immersion heater, controlled by a dual safety thermostat, maintains the water in the tank at a constant temperature.

The tank can be filled with potable water by hose and then transported to location behind a suitable motor vehicle using the standard ball type towing hitch provided. It is designed to enable it to be easily stored when not being used. The tank is mounted on a heavy-duty galvanised mild steel frame and has four braked wheels fitted with standard trailer-type pneumatic tyres. The unit is manufactured according to ANSI Z358.1-2014. Equipment should be installed within 10 seconds reach in case of an accident; no closer than 3 metres or further than 15 metres. The area around and underneath the shower should provide good drainage, especially if there is a possiblilty of the water freezing.

 

Key Features

  • Simple hand operated Shower and Eye/Facewash
  • Stainless Steel Shower pipework
  • Submersible electric pump
  • Water immersion heater
  • Maintains heated water for up to 12 hours
  • Heavy duty galvanised trailer unit
  • 2000 litre unit with a twin axle
  • Rigid safety sign with bracket
  • Trailer weight (unladen): 460Kg
  • Trailer weight (full): 2460Kg

 

HEATED AND SELF-CONTAINED MOBILE SHOWER AND EYE/FACEWASH WITH SUBMERSIBLE WATER PUMP

  • Designed in accordance with ANSI and EU guidelines where applicable
  • Suitable for all climates
  • Covered Eye/Facewash bowl to protect against airborne contaminants - Lifting lid provides simple operation even with impaired vision
  • Hughes ball valve for greater reliability and longer life

 

Installation Instructions

  • Fill unit with clean potable water
  • Connect the power to the unit and leave for a minimum 6-8 hours to warm the water
  • The immersion heater power rating is 3Kw @ 240V & 1.7Kw @ 110V 1Ph 50/60Hz
  • Position unit in desired location
  • Ensure brakes on the unit are applied
  • Connect shower pipework to the operating valve on the unit
  • Ensure shower valve lever in upright position (closed)
  • Connect electricity supply
  • Test unit to verify proper operation
  • Unit is now ready to be used

 

Maintenance Instructions

  • Empty contained water regularly or after use
  • Unit should be serviced and cleaned regularly, at least every six months to ensure proper operation
  • Clean shower with non-abrasive cleaners only
  • Remove overhead shower nozzle, inspect and disinfect every six months
  • Remove eye/facewash nozzles, inspect and disinfect every six months (replace regularly)
  • Regular checks of all fastenings fixings
  • Regularly check all electrical equipment and connections

Note: Empty all water when storing

 

Operating Instructions

  • Operate shower handle downwards to operate shower
  • Pull lid of eye/facewash downwards to operate
  • After use seek medical assistance
Related Categories


Request a Quote Now

Request a Quote X

Your Name*
Please let us know your name.

Company Name
Invalid Input

Your Email*
Please let us know your email address.

Phone*
Invalid Input

Category*
Please enter valid Product/Category

Product Url
Enter valid Product Url

Comment
Please let us know your message.

Captcha*
Captcha   RefreshPlease enter the right CAPTCHA

Processing...