MSA Safety Page 13

MSA Safety Page 13

For more information, call Western Safety Products at 206-264-0808 or email sales@westernsafety.com.

Credit Card Images

**HAZMATCAD & HAZMATCAD Plus Hazardous Material Chemical Agent Detectors**

HAZMATCAD Detector The HAZMATCAD Hazardous Material Chemical Agent Detector is a handheld instrument that detects and classifies Chemical Warfare Agents (CWA). When compared to other technologies, the HAZMATCAD Detector offers more capabilities and greater reliability at a lower cost. Features: Compact, light-weight and portable Self-diagnostic check during rapid warm-up Alphanumeric display with LED alarms Dual-Mode SAW Operation-Fast or High Sensitivity Operates between 8 and 12 hours on rechargeable Li-Ion batteries Vapor-diffusion check source verifies system performance Unit can be hand-carried or worn on belt RS-232 and IrDA communication ports; stores up to 8 hours of data Inlet design protects against dust and particulates HAZMATCAD Plus Detector The HAZMATCAD Plus Detector detects for Chemical Warfare Agents (CWA) and selected Toxic Industrial Chemicals (TICs). It is a portable instrument designed for one-hand operation. It is very easy to operate and requires limited training for effective use. Features: Self-diagnostic check during rapid warm-up Alphanumeric display with LED alarms Dual-Mode SAW Operation - Fast or High Sensitivity Electrochemical Cells - Real time analysis Operates between 8 and 12 hours on rechargeable Li-Ion batteries Vapor-diffusion check source verifies system performance RS-232 and IrDA communication ports; stores up to 8 hours of data Inlet design protects against dust and particulates
Kits include: HAZMATCAD Detector; battery charger; belt clip; two Sony rechargeable batteries; hard, water-resistant carrying case; operating manual; vapor check source
Part No.	Instrument	Chemical Agents Detected
10055094	HAZMATCAD Detector	Nerve and Blister
10055095	HAZMATCAD Detector	Nerve, Blister and Hydrogen Cyanide
10055096	HAZMATCAD Detector	Nerve, Blister and Phosgene
10055097	HAZMATCAD Plus Detector	Nerve and Blister agents and TICs (phosgene, hydrogen cyanide, halogen and hydride gas)

**HazMat Response Kit**

The HazMat Response Detector Tube Kit can be used by firefighters, HazMat Response Teams and other workers to help classify unknown chemical gases and vapors at accident or spill sites. A Quad-Port Sampler allows four chemical classes to be tested simultaneously. The portable kit contains 12 types of Detector Tubes (each with sufficient tubes for 10 complete tests), a Kwik-Draw Pump to draw the sample through the tubes, the multiple tube holder and a convenient, easy-to-follow interpretation guide. Features & Benefit:s Quickly classifies unknown chemical gases and vapors Quad-Port Sampler allows simultaneous testing with four detector tubes, meaning less time in IDLH atmosphere Flow-limiting orifices ensure even sample flow Portable and easy to handle Includes simple interpretation guide
807472	Includes 12 types of detector tubes, multiple tube holder, Kwik-Draw Pump and interpretation guide
485233	Extra Quad-Port Sampler

**SafeSite Multi-Threat Detection System**

The SAFESITE Multi-Threat Detection System simultaneously monitors and wirelessly communicates six potential threats: CWAs, VOCs, TICs, gamma radiation, combustible gas and oxygen deficiency. The SAFESITE System combines state-of-the-art detection technology with advanced wireless communication capabilities to provide superior preventative and counter-measure solutions for: Homeland Security Emergency Response Public Events Building Protection Mass Transportation Centers Perimeter Monitoring Hazardous Response Port Surveillance Confined Space Monitoring SAFESITE System components consist of the SAFEMTXTM Multi-Threat Detector, the SAFECOM™ Command Center and the SAFECONNECT™ Belt-Bridge with Sirius wireless interface. The system can be installed permanently (wired or wireless) for continual monitoring or deployed as a portable system. The SAFEMTX Multi-Threat Detector utilizes mUlti-sensing technologies to detect up to six potential threats; helping first responders, law enforcement and government agents reduce the risk of exposure and facilitate consequence management. The SAFECOM™ Command Center receives mission-critical information from the SAFEMTX™ Detectors and permits this crucial and wide-ranging data to be converted quickly into practical information for rapid decisionmaking through an uncomplicated graphical user interface. The SAFECOM Command Center can manage up to four systems with 16 SAFEMTX Detectors per system, integrating SAFEMTX data, including: Gas readings Relative CWA threat level Radiation dose rate Alarm status GPS location Battery run time RF signal strength Fault conditions SAFEMTX min, max, and average values Through the SAFECOM Command Center, alarms are identified with both visual and audible alarms. Alarms can then be acknowledged and silenced, detectors can be enabled and disabled, event logs and event log history can be viewed, plus units can be customized to suit the specific deployment scenario. Wireless Technology: The SAFESITE® System provides up to two miles of wireless communication between any SAFEMTX Detector, SAFECONNECT Belt-Bridge and SAFECOM Command Center. SAFECONFIG™ Software works with the SAFECOM Command Center or SAFECONNECT Belt-Bridge, enabling configuration of any SAFEMTX Detector as a repeater. This added capability maximizes deployment range and ensures maximum signal strength and reliable deployment without the need to move units. SAFEPAC™ Perimeter Area Command Kit: SAFESITE® SAFE PAC Perimeter Area Command Kit provides a basic kit for quick deployment and monitoring of an event or a location. The kit includes two Pelican cases with an internal battery charger, 4 SAFEMTX™ Multi-Threat Detectors, 1 SAFECOM™ Command Center, all necessary PC interface software, and 4 extra batteries. A laptop PC is also available as an option, or an existing PC can be used.
Chemical warfare agents	Surface acoustic wave (SAW)	Low false positives and false alarms, differentiates nerve & blister agents
Gamma radiation	Cadmium zinc telluride (CZT)	Sensitive with adjustable threshold and 2 ranges. (0-100 mR/hr, 0.1 mR/hr resolution & 0-1000 mR/hr, 1 mR/hr resolution)
Volatile organic compounds	Photo-ionization (PID)	10.6 eV lamp provides ppm readings for broadband toxics and VOC detection
Toxic industrial chemicals	Electrochemical	Detects many specific toxic gases such as chlorine, ammonia, hydrogen cyanide and hydrogen chloride
Oxygen deficiency/ enrichment	Electrochemical	Oxygen monitoring for confined space
Combustible gas	Catalytic bead	Wide range detection for hydrocarbons

**SafeCom Command Center**
The SAFECOM Command Center receives mission-critical information from the SAFEMTX Detectors and permits this crucial and wide-ranging data to be quickly converted to practical information for rapid decision-making through an uncomplicated graphical user interface. The SAFECOM Command Center can manage up to two systems with 16 SAFEMTX Detectors per system, integrating SAFEMTX data, including: • Gas readings • Relative CWA Threat Level • Radiation dose rate • Alarm status • GPS location • Battery run time • RF signal strength • Fault conditions • SAFEMTX min, max, and average values Through the SAFECOM Command Center, alarms are identified with both visual and audible alarms; alarms can then be acknowledged and silenced, detectors can be enabled and disabled, event logs and event log history can be viewed, plus units can be customized to suit specific deployment scenarios. The SAFECOM Command Center maps SAFEMTX Detectors through GPS technology, specific address input or “click and dragging” icons onto images. The SAFECOM Command Center is also a TCP/IP hub, allowing all information to be placed on a network for remote viewing. Wireless Technology: The SAFESITE System provides two miles of wireless communication between any SAFEMTX Detector and SAFECOM Command Center and when necessary, the SAFECOM Command Center can configure any SAFEMTX Detector as a repeater to ensure maximum signal strength and reliable deployment without the need to move units.
SAFEPAC™ Perimeter Area Command Kit SAFESITE SAFEPAC Perimeter Area Command Kit provides a basic kit for quick deployment and monitoring of an event or a location. The kit includes two Pelican Cases with an internal battery charger, 4 SAFEMTX Multi-Threat Detectors, 1 SAFECOM Command Center, all necessary PC Interface software plus 4 extra batteries. A laptop PC is also available as an option or you can use an existing PC. 1: Case – weather-resistant case provides for safe storage of system components 2: Internal battery charger – allows charging of system batteries while in storage. Charges 4 back-up lithium-ion batteries 3: SAFEMTX Detectors – stores up to 4 customer specified units and powers them through AC connection 4: SAFECOM Command Center – storage for SAFECOM Command Center plus laptop PC 5: Calibration kit – storage for calibration kits in SAFECOM box (kit is optional) 6: Storage compartments – storage for all power cords, adapters, manuals, calibration cylinders and other relevant equipment

**SafeConnect Belt-Bridge**

The SAFECONNECT™ Belt-Bridge works with the Sirius Detector for integration into the MSA SAFESITE® Multi-Threat Detection System. These new system components offer up to two miles of wireless communication plus an updated Graphical User Interface (GUI) which provides all mission-critical information in one uncomplicated format. SAFECONNECT Belt-Bridge Interfaces wirelessly to existing Sirius Multigas PID Detector Provides GPS location tracking in real time Utilizes the same 1-watt, 900 MHz, spread spectrum, frequency hopping radio of the SAFEMTX™ detector and enables up to two miles communication between the SAFECONNECT wireless belt-bridge and the SAFESITE command center Includes a 15-minute quick charger that rapidly restores the AA NiMH rechargeable batteries
Specifications: SAFECONNECT™ Belt-Bridge
Size	6.5"x4.5"x2.5"
Weight	1.2 lbs
Ingress Protection Rating	IP54
Temperature	-20 to +50C (-4 to +122F)
Humidity	Operating humidity range 0-95% RH, non-condensing
Wireless Interface	902 - 928 MHz, 1 watt, spread spectrum, frequency-hopping radio
Communication Range	2 miles line-of-site back to command station
GPS Location	Standard
Battery Type	4 AA NiMH rechargeable or alkaline batteries
Battery Charge Time	15 minutes
Battery Runtime	12 hours nominal
Warranty	One year parts and labor standard
Specifications: Sirius® Wireless Interface
Size	3.5"x2.1"x1.0"
Weight	0.15 lbs
Ingress Protection Rating	IP54
Temperature	-20 to +50C (-4 to +122F)
Humidity	Operating humidity range 0-95% RH, non-condensing
Wireless interface	Bluetooth technology
Communication Range	6 feet to SAFECONNECT Belt-Bridge
Battery Type	CR2477 1000mAH replaceable coin cell
Battery Runtime	18 months (50 hours per week operation)
Warranty	One year parts and labor standard
Ordering Information
Part Number	Description
10071439	SAFECONNECT Belt-Bridge Assembly
10073837	Sirius Wireless Kit, includes extended boot and wireless module
10073312	SAFECONFIG Installation Software

**BIOSENSOR 2200R Biological Agent Detector**

BIOSENSOR™ 2200R Biological Agent Detector The new BIOSENSOR 2200R Biological Agent Detector from MSA is a handheld, portable, on-site instrument for rapid detection, analysis, and identification of biological agents. Unique bioassay technology offers excellent sensitivity and low false positives while offering ease of use during white powder response calls. This highly accurate detection method provides rapid measurement of biohazards such as anthrax, ricin, botulism, SEB, and plague. Exclusive five minute time-to-answer allows first responders to make informed critical decisions more rapidly than any other biological agent detector. The BIOSENSOR 2200R employs dynamic surface generation, a patent pending type of immunoassay detection technology. This technology offers significant advantages over other field-based assay methods by combining the benefits of both the free solution and lateral flow types. The result is more rapid analysis, a user-friendly format, and detector stability within a wide range of climates. Both wet and dry samples may be tested and results are displayed with a simple red (target presentl or green (no target presentl indication. As tests are nondestructive, samples may be retained as evidence. Single-test, disposable cartridges with on-board reagents have a 12-month shelf life. This instrument is permanently housed in a sturdy, lightweight Pelican case. Instrument Features and Benefits 5 minute time-to-answer Uses positive and negative control cartridges Battery-operated with ability to run 50 tests on a single charge Fully deconable housing; IP67 rated Visual and audible alarms provide clear indication of status Extremely easy to use with a training time of one hour Integrated RFID (radio frequency identificationl for automatic cartridge recognition Targets Anthrax/ricin duplex-one test, two agents Anthrax Ricin SEB (staphylococcal enterotoxin B) Botulism* Plague* Smallpox* Tularemia* Cholera* West Nile virus* * Additional agent in development
10084834	MSA BIOSENSOR 2200R Biological Agent Detector Kit*, includes carry case, charger, cartridge starter kit (10084758), instruction manual, and quick start guide
BIOSENSOR Cartridge Plans
10084758	MSA BIOSENSOR cartridge starter kit includes 3 Anthrax/Ricin dual kits**, 1 Anthrax, 1 Ricin, 3 positive control, 2 negative control cartridges, and 2 wet sample kits
10084753	MSA BIOSENSOR Low volume cartridge plan includes 6 Anthrax/Ricin dual kits**, 2 Anthrax, 2 Ricin, 6 positive control, 2 negative control cartridges, and 2 wet sample kits
10084754	MSA BIOSENSOR Medium volume cartridge plan includes 24 Anthrax/Ricin dual kits**, 6 Anthrax, 6 Ricin, 24 positive control. 6 negative control cartridges, and 4 wet sample kits
10084755	MSA BIOSENSOR High volume cartridge plan includes 60 Anthrax/Ricin dual kits**, 8 Anthrax, 8 Ricin, 60 positive control. 8 negative control cartridges, and 6 wet sample kits .
* Extended warranties available ** Each biohazard cartridge test kit includes a dry sample kit.

WSP home page	Products page	Suppliers page
	MSA Index	Previous MSA Page	Next MSA Page