For more information, call Western Safety Products at 206-264-0808 or email sales@westernsafety.com.
 |
|
| • For use with multimeters with DC milli-volt input (1mVDC per 1 degree of F or C) • Selectable Fahrenheit or Celsius measurement • Supplied with the TPK-56 K-type Thermocouple (-50°F to 600°F) • Range can be extended from -58°F to 1830°F by using any properly rated K-type thermocouple |
|
| Temperature Range | Accuracy |
| -58°F to -5.8°F | ± 2.0% Rdg + 4°F |
| -50°C to -21°C | ± 2.0% Rdg + 2°C |
| -4°F to 662°F | ± 0.5% Rdg + 4°F |
| -20°C to 350°C | ± 0.5% Rdg + 2°C |
| 664°F to 932°F | ± 2.0% Rdg + 4°F |
| 351°C to 500°C | ± 2.0% Rdg + 2°C |
| 933°F to 1832°F | ± 2.9% Rdg + 4°F |
| 501°C to 1000°C | ± 2.9% Rdg + 2°C |
 |
|
| • Accessory for multimeters and clamp-ons with temperature input • Converts single temperature input to a dual temperature • Computes differential temperature between probes |
|
| Optional Accessories | Part Number |
| Thermocouple, -50°F to 600°F | Two of TPK-56 |
left to right: TPK-56, TPK-59 |
| TPK-56: Bead Type-K Thermocouple • Accessory for the TMA-K and the DKTA-620 • Measures temperature from -50°F to 600°F TPK-59: Thermocouple |
 |
 |
| MTL-90B: Set of test leads with alligator clips
• High quality set of test leads with alligator clips |
VRC-320: Set of push on alligator clips |
 |
|
| • Converts the USB port of a personal computer to the RS-232 • Supports Windows 95(OSR2X), 98, 2000, ME, XP Mac 8.6 and higher • Works with Amprobe instruments with download capabilities • Works with many other products with USB ports, including cameras, palm pilot, card readers, mouse, security systems, etc. • Will free up the serial port for other uses • CE and FCC approved |
|
| Features | Range |
| Baud Rate | Up to 1 MB per second |
 |
|
| • “Must have” accessory for Clamp-Ons • Splits two conductor line cord to permit Amps measurement with Clamp-On • Allows direct Current reading in 1X mode • Increases sensitivity of Current measurement in 10X mode • Voltmeter output jacks for simultaneous voltage measurement • Up to 15 Amps continuous current (up to 20 Amps for one minute maximum) • Plugs directly to an outlet or can be connected with test leads adapter • Can be connected in series with permanently wired equipment |
|
| Optional Accessories | Part Number |
| Ground Adapter | ADP-46 |
| Replacement Parts (supplied with product) | Part Number |
| Alligator Clip Adapter | RAL-4 |
| Alligator Clip Adapter RAL-4 and Red Shortening Cap | ADP-45Alligator |
| Carrying Case | SV-U |
 |
| • Permits use of the A47L with three prong ground plugs and receptacles |
 |
 |
| R-115S: Momentary switch type relay (3 wire) | RC-120S: Closet-light type relay (2 wire) |
| • Switches AC power ON and OFF using low voltage control circuit • Built in transformer, no step down transformers necessary • Single relay can be controlled by multiple switches and multiple relays can be controlled by single switch • Light #22 cable can be used to control relay instead of Romex or armored cable – significant time and cost savings • AC Voltage from 105 to 125V • AC Current up to 6.5A (1/4 HP max. motor load at 120V) • Frequency: 60 Hz • Safe control switching: 10VDC max. and 10 milliamps max. • Safety: UL listed |
|
| Optional Accessories | Part Number |
| Switch | RE-SW |
| Mounting bracket | MB-1 |
| Solder-less connector | STA-1 |
| Switch plate, 1 gang Brushed Stainless Steel (can be painted) | SPR-1 |
| Switch plate, 2 gang Brushed Stainless Steel (can be painted) | SPR-2 |
| Switch plate, 3 gang Brushed Stainless Steel (can be painted) | SPR-3 |
 |
 |
 |
| WSP home page | Products page | Suppliers page | |
| Electrical Safety | Amprobe Index | Previous Amprobe Page | Next Amprobe Page |